Problem B
Pile Up!

There are cubes of the same size and a simple robot named Masato. Initially, all cubes are on the floor. Masato can be instructed to pick up a cube and put it on another cube, to make piles of cubes. Each instruction is of the form `pick up cube A and put it on cube B (or on the floor).'

When he is to pick up a cube, he does so after taking off all the cubes on and above it in the same pile (if any) onto the floor. In contrast, when he is to put a cube on another, he puts the former on top of the pile including the latter without taking any cubes off.

When he is instructed to put a cube on another cube and both cubes are already in the same pile, there are two cases. If the former cube is stacked somewhere below the latter, he put off all the cube above it onto the floor. Afterwards he puts the former cube on the latter cube. If the former cube is stacked somewhere above the latter, he just ignores the instruction.

When he is instructed to put a cube on the floor, there are also two cases. If the cube is already on the floor (including the case that the cube is stacked in the bottom of some pile), he just ignores the instruction. Otherwise, he puts off all the cube on and up above the pile (if any) onto the floor before moving the cube onto the floor.

He also ignores the instruction when told to put a cube on top of itself (this is impossible).

Given the number of the cubes and a series of instructions, simulate actions of Masato and calculate the heights of piles when Masato has finished his job.

Input

The input consists of a series of data sets. One data set contains the number of cubes as its first line, and a series of instructions, each described in a separate line. The number of cubes does not exceed 100. Each instruction consists of two numbers; the former number indicates which cube to pick up, and the latter number indicates on which cube to put it. The end of the instructions is marked by two zeros.

The end of the input is marked by the line containing a single zero.

One data set has the following form:

m
I1 J1
I2 J2
...
In Jn
0 0

Each cube is identified by its number (1 through m). I_k indicates which cube to pick up and J_k indicates on which cube to put it. The latter may be zero, instructing to put the cube on the floor.

Output

Output the height of each pile (the number of cubes in the pile) in ascending order, separated by newlines. A single cube by itself also counts as `a pile.' End of output for one data set should be marked by a line containing the character sequence `end' by itself.

Sample Input

3
1 3
2 0
0 0
4
4 1
3 1
1 2
0 0
5
2 1
3 1
4 1
3 2
1 1
0 0
0

Output for the Sample Input

1
2
end
1
1
2
end
1
4
end

First Input Data

Test your program against this first input data.